Toshiba IK-WB30A - Manual (Page 17)

17
Network Deployment
In this user’s manual, “User” refers to whoever has access to the Network Camera,
and “Administrator” refers to the person who can configure the Network Camera and
grant user access to the camera.
Network Deployment is shown in the Quick Start Guide(QSG). Please refer to 14 pages of QSG.
Setting up the Network Camera over the Internet
There are several ways to set up the Network Camera over the Internet . The first way is to set
up the Network Camera behind a router . The second way is to utilize a static IP . The third way is
to use PPPoE .
Internet connection via a router
Before setting up the Network Camera over the Internet, make sure you have a router and follow
the steps below.
1. Connect your Network Camera behind a router, the Internet environment is illustrated below.
Regarding how to obtain your IP address, please refer to Software Installation on page 19 for
details.
Hardware Installation
Please verify that your product package contains all the accessories listed in the Package
Contents listed on page 13. Depending on the user’s application, an Ethernet cable may
be needed. The Ethernet cable should meet the specs of UTP Category 5.
Hardware Installation is shown in the Quick Start Guide(QSG). Please refer to 13 pages of
QSG.
IP address : 192.168.0.3
Subnet mask : 255.255.255.0
Default router : 192.168.0.1
IP address : 192.168.0.2
Subnet mask : 255.255.255.0
Default router : 192.168.0.1
LAN (Local Area Network)
Router IP address : 192.168.0.1
WAN (Wide Area Network )
Router IP address : from ISP
Cable or DSL Modem
LAN (Local Area Ne
Router IP address :
WAN (Wide Area Network )
Router IP address : from ISPP
POWER COLLISION LINK RECEIVE PARTITION 1 2 3 4 5
Internet
This client PC sets up
a camera and a router.
Example Network Environment
Installation