Toshiba IK-WB30A - Manual (Page 14)

14
Front Panel
Back Panel
General I/O Terminal Block
This Network Camera provides a general I/O terminal block which is used to connect external
input / output devices. The pin definitions are described below.
● Only when a power supply connects to a camera, 12V DC is outputted from 1-pin.
● When an AC adapter or PoE is connected, don’t supply AC24V from this terminal.
8 7 6 5 4 3 2 1
Pin Name
1 12V DC Output
2 Digital Output
3 Digital Input
4 Ground
5 Power in 24V AC
6 Power in 24V AC
7 RS-485 +
8 RS-485 -
Built-in Microphone Light Sensor
Power Cord Socket
Ethernet 10/100 RJ45 Socket
Recessed Reset Button General I/O Terminal Block
Audio Out
External/Internal MIC Switch
Microphone In
Status LED
SD/SDHC Card Slot
Physical Description
CS Lens Mount Ring
Fixing Hole
When you connect
a wire, or when you
disconnect it, please
p u s h t h i s o r a n g e
push-button.
NOTE