Texas Instruments 3000 WinSX - Manual (Page 99)

Guidelines for Installing Applications
Default CONFIG.SYS File
Each line of the TravelMate 3000 WinSX default CONFIG.SYS file and its purpose are
defined in the table following the file listing. You can add commands required by your
application program(s), but do not delete the existing default commands.
DEVICE=C:\DOS\SETVER.EXE
DEVICE=C:\DOS\HIMEM.SYS
DOS-HTGH
FILES=30
BUFFERS=30
STACKS=0,0
FCBS-I
SHELL=C:\DOS\COMMAND.COM /P /E:256
DEVICE=C:\DOS\SMARTDRV.SYS 2048 1024
DEVICE=C:\UTILS\BATTERY.PRO
INSTALL=C:\D0S\FAST0PEN.EXE C:=(60,30)
REM To enable the TI mouse unREM the line containing
TIMOUSE.SYS
REM DEVICE=C:\UTILS\TIMOUSE.SYS
Factory Default CONFIG.SYS File
(Modify but do not delete these commnand lines)
Line Purpose
1 tells some applications current DOS version
2 installs extended memory manager device driver
3 loads MS-DOS into extended memory
4 tells MS-Dos how many files can be open at any one time; you can
adjust the value as required by your application
5 tells MS-DOS how many buffers will be used for file input/ output; you
can adjust the value as required by your application to maximize
processing speed
6 reserves memory for MS-DOS to process hardware interrupts
7 number of file control blocks MS-DOS can concurrently open
8 tells applications path to command processor
9 installs device driver that creates disk cache in extended memory with
initial and minimum cache sizes
10 loads the device driver used to save battery power
11 loads the fastopen command, which decreases time needed to open files
and directories
12 comment line describing the TIMoUSE mouse driver
13 delete the REM to enable the mouse device driver to install
5-6 Installing and Using Application Programs