Texas Instruments 3000 WinSX - Manual (Page 37)

Keyboard Keys
Break
Pressing the Ctrl-Pause (Break) keys sends a Break signal to stop current program
execution. Your application program may have other or additional functions for the Break
signal.
Set Up
Pressing the Fn-Esc (Set Up) keys when the computer displays the MS-DOS C:\> prompt
loads the Setup Program from the hard disk. The Setup Program permits you to configure
the computer's basic functions. Although not recommended, you also can load the Setup
Program from ROM while you are working in some application programs (but not
Windows) by pressing the Ctrl-Alt-Esc keys.
See Chapter 4 for details on using the Setup Program.
Stndby (Standby)
Pressing the Fn-F4 (Stndby) keys sets the TravelMate 3000 WinSX to the Standby mode
and the processor to the " sleep" mode that turns off both the LCD display and the hard
disk drive. In this mode the processor responds only to pressing the Fn-F4 keys again,
which causes the system to resume normal operation.
The Power indicator light glows orange when the computer is in the Standby mode.
You can use the Standby mode to transport the computer for short distances. You also can
close the display/cover to transport the unit (after the five beeps are completed).
Note: See Chapter 4 of this manual and see the BatteryPro & Productivity Software
User’s Manual furnished with your computer for more details on the Standby and other
power-saving modes.
Learning About Your Computer 2-17