Toshiba RAV-SM800XT-E - Manual (Page 64)

– 62 –
No. Part name Procedures Remarks
2
6) Remove both side hooks and remove the
Front panel by turn to air inlet part
direction.
1) In case of the Drain hose installation
through the Front panel, install the opening
base for piping in the Back body by a screw
(M4 x 12). Prepare it by yourself.
2) Fit the Front panel in the Drain pan. Then
fix it in the Drain pan with 2 hooks in the
center of the air outlet.
3) Fix 5 hooks around the Front panel with
conformation the Guide-rib is inserting into
the Back body.
4) Fix 8 screws and close 3 Cap screws.
5) Install the Drain band into the Front panel.
6) Check the gap between the Front panel
and the Back body.
3
1) Remove the Air inlet grille and the Front
panel. (
1
,
2
)
2) Remove the Louver motor from the Drain
pan.
3) Remove the shaft of Horizontal louver.
4) Remove the LED base and Electrical wire.
5) Remove the TA sensor wire.
6) Remove the Drain hose.
Front panel
Drain pan
assembly
Louver motor
Electrical wire LED base
Shaft of Horizontal lover
Drain hose TA sensor
(Continue)
Hook
Guide-rib