Toshiba E-STUDIO 3511 - Manual (Page 284)

282
12.WHEN THE GRAPHIC SYMBOLS BLINK ON THE TOUCH PANEL
7.REMOVING JAMMED STAPLES (OPTIONAL) (Cont.)
12
8 Return the saddle staple to its original
position.
- Pull the handle of the saddle stitch holder (1) toward you and turn
it (2) 90º in the direction of the arrow.
9 Return the saddle stitch unit to its original
position.
10 Make sure that LD, LG or LT-R paper is set.
- If any of the above paper sizes is not set, test stapling cannot be
performed.
11 Close the front cover of the finisher. Then
test stapling is automatically performed
on a blank sheet.
- This is performed to avoid empty stitching.
If there is a test stapling failure and “Check staple cartridge”
remains, repeat the above procedure from step 1 to 11.
(1)
(2)