Telit Wireless Solutions GE863 - Manual (Page 58)

GE863-GPS Software User Guide
1vv0300724 Rev. 2 - 24/01/07
- page number
- total number of pages of the message
- CBM Content of Message
- SMS-STATUS-REPORTs reporting option
0 - status report receiving is not reported to the DTE
1 - the status report is sent to the DTE with the following unsolicited result code:
(PDU Mode)
+CDS:
where:
- PDU length
- message PDU
(TEXT Mode)
+CDS: ,,,,,
2 - if a status report is stored, then the following unsolicited result code is sent:
+CDSI: ,
where:
- memory storage where the new message is stored
"SM"
- location on the memory where SM is stored
- buffered result codes handling method:
0 - TA buffer of unsolicited result codes defined within this command is flushed to the TE when
=1..3 is entered (OK response shall be given before flushing the codes)
1 - TA buffer of unsolicited result codes defined within this command is cleared when =1..3
is entered.
NOTE: issuing AT+CNMI is the same as issuing the Read command.
NOTE: issuing AT+CNMI= is the same as issuing the command AT+CNMI=0.
• wait
for
OK
TIP: In this command description the values that are always 0 are parameter reserved for future
use, in the current software revision the only value supported is 0.
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 58 of 109