Telit Wireless Solutions GE863 User Manual
Page 53
GE863-GPS Software User Guide
1vv0300724 Rev. 2 - 24/01/07
Response
Reason
Action
OK
The power save is now active
ERROR
some error occurred
Enable extended result codes
(see par. 2.5.2.1), and retry.
+CME ERROR: 4
operation not supported
Check command syntax and
TIP: The power saving function is disabled by default when the device starts up, in order to
guarantee that even without the DTR line support it is possible to exchange commands with
the module; for this reason the power saving setting command shall be issued after every
power up.
NOTE: The power saving for GSM part will not be activated if the GPS part is switched on.
The DTR functionality is usable only when +CFUN=5 is selected.
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 53 of 109