Telit Wireless Solutions GE863 - Manual (Page 43)

GE863-GPS Software User Guide
1vv0300724 Rev. 2 - 24/01/07
3.2.3.1 CLIR Service status query
•
send command AT+CLIR?
•
wait for response in the format:
+CLIR: ,
OK
where:
is the facility status on the Mobile
0 – CLIR facility according to CLIR service network status
1 – CLIR facility active (CLI not sent)
2 – CLIR facility not active (CLI sent)
is the facility status on the Network
0 - CLIR service not provisioned (service unavailable)
1 - CLIR service provisioned (service available)
2 - unknown (e.g. no network present, etc.)
3 - CLI temporary mode presentation restricted
4 - CLI temporary mode presentation allowed
NOTE: The parameter reports the status of the service at network level.
If the CLIR service is not provisioned, then it is not possible to use this service and changing
the first parameter will not change the CLI presentation to the other party behavior of the
network.
For example:
1- Let's assume you want to check your CLIR settings:
command:
AT+CLIR?
response:
+CLIR: 2,4
In this case the CLIR service is temporary mode allowed on the network and the mobile sends the CLI
when calling. (CLI Restriction not active).
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 43 of 109