Tiger Products Co., Ltd CNH T6010-80 - Manual (Page 65)

ASSEMBLY
Assembly Section 2-33
SELECTOR VALVE RELOCATION
Drill a set of Ø3/8” or Ø10MM holes 1-1/2” to the right of the existing holes on the
Leagal Rear Stow Boomrest. Install the selector valve using the hardware provided as
shown in the parts section of this manual..
(ASM-NH-0079)
SELECTOR VALVE INSTALLATION
The selector valve is attached to the boom rest as noted above. The 1/4” hoses from
the swivel section of the lift valve are plumbed to the “A” and “B” ports on the selector
valve. A run tee is added to the return section of the lift valve. Attach the 1/2” hose from
the “T” port of the selector valve to the run tee as shown in the parts section. 1/4” hoses
are attached to the “A1”, ”A2”, “B1” & “B2” ports on the selector valve to the knuckle
cylinder and swivel cylider (as shown below and in the parts section)..
(ASM-NH-0080)