Tiger Products Co., Ltd CNH T6010-80 - Manual (Page 40)

ASSEMBLY
Assembly Section 2-8
6 CYLINDER EXHAUST MOUNT
NOTE: This should be done after mounting the main frame.
1.
Cut the tractor hood as shown in below to accomodate modified exhaust turbo tube.
2. Remove the muffler from existing turbo tube.
3. Remove existing turbo tube from tractor turbo.
4. Install the exhust mounting bracket and supporting brace.
5. Install the modified turbo tube to the tractor turbo with existing hardware. Do not
tighten the hardware.
6. Install the exhaust clamp to the exhaust mounting bracket with the supplied
hardware. Refer to the Parts Section for details.
7. Tighten the turbo existing hardware.
8. Cut the muffler 8” off at the top as shown below and weld the sweep back onto the
top of the muffler maintaining the same direction. Then install muffler to the turbo
tube with the existing hardware.
(ASM-NH-0057)