Assembly, Lift valve mounting – Tiger Products Co., Ltd CNH T6010-80 User Manual
Page 55
ASSEMBLY
Assembly Section 2-23
LIFT VALVE MOUNTING
Drill a Ø9/16” hole in the fender frame tube of the tractor 3/4” back of the existing hole (away
from cab). Install the valve mounting bracket to the inside of the right and left rear fender frame
tube as shown below and attach it with hardware listed in the Parts Section of this manual.
Repeat these steps for the left valve mounting bracket.
Align the valve mounting plate with the drilled holes. Mark the center of one of the holes
above and in-line with the slotted holes in the valve plate. Do not use any holes that will be used
to mount the valve onto the plate.
Mount the lift valve with the supplied hardware. Refer to the Parts Section for the details.
(ASM-NH-0066)