Tiger Products Co., Ltd CNH T6010-80 - Manual (Page 46)

ASSEMBLY
Assembly Section 2-14
LOAD SENSE HOSE ROUTING - OPEN CENTER
(CONTINUED)
On a tractor with an Open Center system with Open Center ports, the lift valve
uses the Pressure, Return and Power Beyond ports on the tractors rear remotes.
The ports used are directly under the valve mounting plate as shown below.
(ASM-
NH-0062A)
The Pressure and Return lines are routed the same as stated above, however, the
Load Sense line is routed differently. On a tractor with a cable control lift valve,
the Load Sense line is routed directly to the power beyond remote on the tractor.
On a tractor with an electronic lift valve, the load sense line is routed to the priority
LOAD SENSE HOSE ROUTING - CLOSED CENTER
On a tractor with a Closed Center system, the lift valve uses the Pressure and Return
on the tractors rear remotes. The Load Sense line, however, is connected to a port
above the right rear axle.
The Pressure hose is routed from the tractor remotes to the inlet port of the HP filter
on the valve mounting bracket. Then, the outlet port of the HP Filter to the pressure port
on the lift valve.
The Return hose runs from the return port of the lift valve to the tractor remotes.
The Load Sense hose is routed from the load sense port of the lift valve to the load
sense port on the tractor.
For more information refer to the Parts Section page for a complete diagram of the
tractor valve hookup.
(ASM-NH-0078)