Toshiba FS-2600-1 - Manual (Page 148)

5. PROGRAMMING OPERATIONS EO1-11138
5-49
Address 1: Employee Name
1 [ST]
Submode No.
50 [X] |Employee Code| [NS]
1 to 9999
Character Entries [ST]
Max. 12 characters
[AT/TL]
Repeat for another employee.
* Repeatable from here if an employee code is sequential.
Guest Card Reading through the MCR
Address 2: Cashier Code
2 [ST]
*
|Cashier Code| [#]
0 to 99
Address 3: Job Code
3 [ST]
|Job Code| [#]
Max. 20 digits
5.4 How to Access a Program Item
* SET * 02-06-1999 12:34
PROGRAMMING EMPLOYEE
Please input Employee code.
0.00
Pg up Pg dw Enter ↑ ↓
■ Employee Table Setting (Submode 50)
This programming is used to assign a cashier code and a job code to each employee.
CONDITION After Employee Clock-in/Clock-out When you enter 50 and depress the [X] key,
Daily and GT Reset the screen shown below will appear.
OPERATION Mode Lock: SET
Employee Table Programming Contents
Address No. Description of Programming Contents
2 Cashier Code
Enter a manager-assign code (1 to 99). A cashier for which 0 has been entered for a
cashier code cannot sign ON on the register.
NOTE: Do not set the same cashier code for multiple employees.
3 Job Code
Enter a max. 20-digit value combining the job codes 1 to 10. (When you enter a 1-digit
numeric 1 to 9, add 0 before the numeric.) As a result, a maximum of 10 job codes can be
assigned to each employee.
NOTE: Each job definition should be programmed in the Job Code/ Working Hours Setting
(Submode 51).
NOTE: A maximum of 200 employees can be managed.
ex.) To set the following to an employee No. 1.
Employee No. 1: Address 1 (Name): JONES
Address 2 (Cashier Code): 1
Address 3 (Job Code): 010203 (Job Code 1,2,3)