Toro GREENKEEPER 212 - Manual (Page 26)

1. Remove the lower housing cover (A) by pulling
outward on the handle.
2. Remove two phillips screws from the transformer
access cover (B). Pull the cover outward from the
bottom to remove.
3. Three lower mounting holes (C) are provided. The
center hole is open and the outer holes are plugged.
If you intend to use the outer holes for installation,
carefully drill through the plugs with a 3/16" (5mm)
drill bit.
Four wiring access holes are provided in the cabinet
base as follows:
(D) - 1/2" (13mm) for power and equipment ground wires.
(E) - 1/2" (13mm) (plugged) for optional Toro Rain Switch
wires.
(F) - 3/4" (19mm) for sprinkler valve wires.
(G) - 1/2" (13mm) (plugged) for optional Toro remote
control cable.
4. If planning to install the optional Toro components,
remove the plugs as necessary.
Outdoor Model Installation
Preparing the Cabinet for Installation
25
MANU AL START
ON
NEXT
OFF
MANU AL START
ON
NEXT
OFF
PROG RAMS
B C A
R R R R
BATTERY
MANUAL
START
ON
NEXT
OFF
PROGRAMS
B C A
A
B
C
D E F G