Setting program start times 20 – Toro GREENKEEPER 212 User Manual
Page 21
Turn the control dial to the
PROGRAM START TIME
position.
Check the
PROGRAMS
switch setting. If necessary,
reposition the switch to select the desired program.
Program start time number 1 will begin flashing. The
current program start time or OFF will be displayed
for start time number 1. To select a different program
start time number, press the
+/
ON
or the
–/
OFF
button
until the desired number is flashing.
Note: The numbers (1–4) shown at the top of the display
designate program start times and should not be con-
fused with station numbers. The station numbers will be
shown at the bottom of the display when setting zone run
time.
Press the
NEXT
button. The hour digit(s) or OFF will
begin flashing.
Note: To remove the start time, select OFF by
pressing the
+/
ON
and
–/
OFF
buttons at the same
time, and continue at step
.
To set the hour (and
AM
/
PM
), press the
+/
ON
or the
–/
OFF
button until the desired hour is flashing.
Press the
NEXT
button. The minute digits will begin
flashing.
To set the minutes, press the
+/
ON
or
–/
OFF
button
until the desired minute is flashing.
Press the
NEXT
button. The next program start time
number will begin flashing.
To select another start time number, press the
+/
ON
or the
–/
OFF
button until the desired start time num-
ber is flashing.
10. To set, change or remove a program start time for
the start time number selected, repeat all of the
steps starting at step
.
11. To set program start times for another program,
repeat all of the steps starting at step
.
Return the control dial to the
RUN
position.
Setting Program Start Times
20
PGM A
AM
1 2
12
4
6
8
3 5 7
3
4
5
6
7
7
5
9
2
3
9
9
2
1