Running the demo 3 program – Quantum Sun StorEdge L100 User Manual
Page 117
Chapter 6 Running the Demonstration Programs
Running the Demo 3 Program
Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide
101
Running the Demo 3 Program
6
The
Demo 3
program causes the robot to pick a cartridge from a
randomly selected occupied magazine slot and place it back in the
same slot. The robot then moves to another randomly selected
occupied slot and repeats the process.
To run the
Demo 3
program:
1
Verify that at least one magazine is installed in the library and
that at least one cartridge is present.
2
Access the
Demo Programs
screen (see
).
3
Press the
Up
or
Down
buttons to select
Demo 3
.
4
Press
Select
.
The
Demo 3
program starts. This program continues until you
press the
Stop
button.
5
If desired, include the drives or the fixed slot in the test:
a
Press the
Level
button to select the level where the desired
drive or fixed slot is located.
b
Press
Drive 1
or
Drive 2
to include a drive.
c
Press
Fixed
to include the fixed slot.
6
To stop the program, press
Stop
.
The GUI displays a status screen listing the demonstration
program number, the number of cycles completed, and the
status of the test: pass or fail.
7
Press
Back
to return to the
Demo Programs
screen.