Quantum Sun StorEdge L100 - Manual (Page 103)

Chapter 5 Running Diagnostic Programs
Running the Barcode Scanner Test
Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide 87
Running the Barcode Scanner Test
5
The Barcode Scanner test causes the bar code scanner to do a
complete inventory of the library, scanning each magazine location
for the presence of a valid bar code label.
To run the
Barcode Scanner test:
1 Access the Diagnostics Menu screen (see Accessing the
Diagnostics Menu Screen ).
2 Press the Up and Down buttons to select General .
3 Press Select .
The GUI displays the Diags: General screen (see figure 48 ).
Figure 48 Diags:
General Screen
4 Press the Up and Down buttons to select Barcode Scanner .
5 Press Select .
The GUI displays the Diag: Barcode screen, which prompts you
to set the cycle count (see figure 49 ). The rightmost number is
highlighted.