Olympus C-40Zoom - Manual (Page 185)

185
Chapter 12
Troubleshooting
1 The power is off.
2 The batteries are
loaded incorrectly.
3 The batteries are
exhausted.
4 The batteries are
temporarily unable to
function.
5 It is connected to a
personal computer.
6 The camera is in the
sleep mode.
7 The camera is too hot
and has turned off
automatically.
1 Open the lens barrier to turn
on the camera.
2 Reload the batteries
correctly.
3 Replace the batteries with
new ones.
4 The batteries may be too
cold. Keep them warm while
using the camera.
5 The camera will not operate
while it is connected to a
personal computer.
6 Operate the camera (press
the shutter button, turn the
mode dial, etc.)
7 Wait until the camera cools
down before using it again.
P. 30
P. 25
P. 25
P. 170
P. 30
POSSIBLE CAUSES CORRECTIVE ACTION REF. PAGE
The camera does not turn on or function buttons do not respond.
No picture is taken when the shutter button is pressed.
1 The lens barrier is
closed.
2 The memory gauge is
full.
3 The flash has not
finished charging.
4 The card access lamp
blinks after shooting in
the mode.
1 Open the lens barrier.
2 Wait until there is room in
the memory gauge.
3 Release your finger from the
shutter button. When the
orange lamp stops blinking,
shoot again.
4 The recorded movie image
data is being written to the
card. You can start shooting
again when the card access
lamp stops blinking.
P. 30
P. 79, 81
P. 88
P. 81