Oki Pos 407II - Manual (Page 45)

– –
11-1. Parallel Interface Model
ON ON
OFF OFF
DIP-SW
Switch - Command emulation
ON Star Mode
OFF ESC/POS Mode
The factory settings of DIP switch are all on.
The functions of switches - through -0 will change according to the command emulation
that has been set using switch -.
() Star mode
Switch Function ON OFF
- Command emulation Always ON
- Should not be changed (Should be set to on)
- Should not be changed (Should be set to on)
- Sensor adjustment Invalid Valid
- Pin # (INIT) reset signal Valid Invalid
-6 Handshaking conditions
(conditions for BUSY)
Offline or receive
buffer full
Receive buffer full
- Automatic status back function Invalid Valid
- Should not be changed (Should be set to on)
- Low-power consumption mode Invalid Valid
-0 Should not be changed (Should be set to on)
() ESC/POS mode
Switch Function ON OFF
- Command emulation Always OFF
- Graphic adjustment 0 DPI 0 DPI
- Should not be changed (Should be set to on)
- Sensor adjustment Invalid Valid
- Pin # (INIT) reset signal Valid Invalid
-6 Handshaking conditions
(conditions for BUSY)
Offline or receive
buffer full
Receive buffer full
- Automatic status back function Invalid Valid
- Should not be changed (Should be set to on)
- Low-power consumption mode Invalid Valid
-0 Should not be changed (Should be set to on)
No. 1 2 3 4 5 6 7 8 No. 1 2 3 4 9 10
DIP-SW 1 DIP-SW 2