Oki Pos 407II - Manual (Page 40)

– 6 –
10-2. Auto Cutter Specifications
() Cutting frequency Max. 0 cuts per minute
() Thickness of paper 0.06 ~ 0. mm
10-3. Interface
RS-C serial interface/Two-way parallel interface (IEEE)/USB interface/Ethernet in-
terface/Wireless LAN Interface
10-4. Electrical Characteristics
() Input Voltage DC V±0%
() Current Consumption (DC V at room temperature)
Standby: Approx. 0. A
ASCII printing: Approx. average . A
(Approx. .% printing rate)
00% print duty: Approx. peak . A
(Solid printing): Approx. average .0 A
(Continuous solid printing should be 0 seconds or less.)
() Power Connector
Pin No. Function
Drive power ( V)
Signal GND
N.C.
Shell Frame ground
Note:
• When using a printer power supply other than the optional AC adaptor (PS60A-A),
be sure that the following cautions are observed.
• Use a power supply of DC V ±0% and more than .0 A (.0 A Load 0 sec. Min)
with LPS output approved by IEC600.
• Be careful about installing the printer in an area where there is noise. Take the appropri-
ate measures to protect against electrostatic AC line noise, etc.