Oki Pos 407II - Manual (Page 18)

– –
3-7-2. Changing the Adjustment Lever Position
The adjustment lever position must be changed in accordance with the paper thickness. It is
factory-set to position ①. When using paper thickness between 100 and 150 μm, change the
adjustment lever position in accordance with the procedure below.
As shown, use a flat head screwdriver to move the adjust-
ment lever inward. Then, lower the adjustment lever to
the position in which the protrusion on the adjustment
lever engages with the hole in the frame.
Note: Do not use position ②.
Position ③
Paper thickness
between 105 μm and 150 μm
Position ①
Paper thickness
between 65 μm and 105 μm
3-7-3. Removing the Paper Roll Holder
When using a paper roll with an . mm width, remove the paper roll holder as shown.
When using a paper roll with a . mm width, remove the paper roll holder, and install the
paper roll holder into the other groove. In either case, change the setting at memory switch #.
For instructions on setting the memory switch, refer to the separate Specifications Manual.
Note: After using a paper roll with a width of . mm, do not change to a paper roll with
a width of . or . mm. This is because the printer head has deteriorated as a
result of a portion of the head having been in direct contact with the platen.
Paper roll holder