Oki Pos 407II - Manual (Page 26)

– –
5-2. Full-Face Thermal Label Paper Roll
(1) Label paper specification
Backing paper width: .±0. mm or .±0. mm
Outer roll diameter: ø00 mm or less
Take up paper roll width: 0 +0.
-
mm or +0.
-
mm
Thickness: Max. 150 μm
Core outer/inner diameter: core inner diameter ø.± mm/core outer diameter
ø± mm
Printed surface: Outer edge of roll
Tail end handling: Do not use paste or glue to secure the paper roll or its
core.
Do not fold the tail end of the paper.
() Recommended label paper
Manufacturer
Product
name
Quality
features/
applications
Thickness (μm)
Adhesion
type
Base
material
Separator
Total
thickness
Lintec LD For distribution
or information
control
6 High
adhesion
Lintec LD0 For measurement 6 0 High
adhesion
Ricoh 0LHB For distribution
or information
control
– – High
adhesion
Note:
) Depending on the type and thickness of the paper, it may be necessary to change the
settings for printing darkness. To change the darkness settings, use the printing dark-
ness settings command ‘d’ n. Refer to the separate programmer’s manual
for details.
) The print density may vary depending on the type of paper roll, operating environment,
and power consumption mode.
) A reader or scanner may not be able to scan a printed bar code or characters depending
on the print density. Make sure that your reader or scanner is able to scan correctly
beforehand.