Oricom DECT BT9500 - Manual (Page 33)

31
REGISTRATION
IMPORTANT: When you purchase your phone all handsets are
already registered to the base, so you do not need to register them.
Handset registration is only necessary when you buy extra
handsets or if a handset becomes faulty.
Your new telephone system can accommodate up to 6 handsets.
You can add new handsets to your telephone system, but each
device must be registered with the telephone base before use.
Register a handset
1. Press MENU/OK when in idle mode to enter the menu list.
2. Press UP/DOWN to select REGISTER HS.
3. Press MENU/OK and then enter the system PIN. (Default is
0000.)
4. Press MENU/OK, and the display will show PRESS AND HOLD
PAGE BUTTON.
5. Press and hold on the base for about 3 seconds until
the IN USE LED flashes slowly. After a short time, the handset
display will show REGISTERING, and then change to HANDSET
X, where X denotes the handset number (1-5), if registration is
successful.
NOTES
1. If the registration is not successful, the display will show NO BASE FOUND.
Try the registration process again.
2. You cannot register a handset if any other system handset is in use.
De-register a handset
You may need to de-register a handset if you have five registered
handsets and need to replace a unit.
Please read carefully through all the instructions on this page
before beginning the de-registration process.
1. Press MENU/OK when in idle mode to enter the menu list.
2. Press UP/DOWN to select DE-REGISTER HS.
3. Press MENU/OK and then enter the system PIN. (Default is
0000.)
4. Press MENU/OK and then UP/DOWN to select the handset you
wish to remove.
5. Press MENU/OK, and the display will show DE-REGISTER?
6. Press MENU/OK to confirm. Display will show DE-REGISTED if it
is successful which means DE-REGISTERED.
NOTES
You can de-register the handset currently being used.
reGistration