Oricom DECT BT9500 - Manual (Page 16)

14
NOTE
Only Bluetooth headsets with password 0000 can be paired with the telephone
base system.
When a device is successfully connected, the Bluetooth LED for the button
selected will be turned on, and the Bluetooth status icon will display on the
handset screen. The number 1 and/or 2 will also be displayed next to Bluetooth
status icon to indicate the numbers of any Blue too th enab led devices
connected.
If you would like to pair another Bluetooth device, please repeat the steps
above. Be sure to activate a Bluetooth button which is NOT paired to another
Bluetooth device (indicated by the Bluetooth LED light on the base being OFF).
If you activate a Bluetooth button which is already paired to another Bluetooth
device (indicated by the Bluetooth LED light on the base being ON) this will
terminate the connection of the Bluetooth device that was attached and start
the process to connect a new Bluetooth device.
Auto connection
Once you have paired a device with the telephone base, the pairing
information is stored in the telephone base. If the paired device
becomes disconnected, the telephone base will automatically
search and re-connect to that device. If the connection does not
resume in a minute, you will need to reconnect to that device
manually, refer to the section below for details.
Manual connection
To manually re-connect a paired device, make sure the Bluetooth
feature is turned on in your Bluetooth enabled mobile phone, select
BT9500 from the paired device list in your Bluetooth enabled
mobile phone. Once the connection is established again, the
corresponding Bluetooth LED for the button selected will turn back
on.
Turning off the auto connection
If you do not want the telephone base to re-connect to a paired
device automatically after it is disconnected, you can turn off the
auto connection feature manually. In order to turn off the auto
connection, you will need to initiate a disconnection from the paired
Bluetooth enabled mobile phone; this will transmit a signal to the
telephone base and disable the auto connection.
While the Bluetooth enabled mobile phone is connected to the
telephone base, find the Bluetooth enabled mobile phone’s
Bluetooth device list and select BT9500 and manually disconnect
the device.
(If disconnection is not an option on your Bluetooth enabled mobile
phone, you may need to disable Bluetooth or unpair the telephone
base.) Refer to your Bluetooth enabled mobile phone’s user’s
guide for instructions. The telephone base will not search and
re-connect to this Bluetooth enabled mobile phone until this feature
is activated again.
introduCinG Bluetooth