Oricom DECT BT9500 - Manual (Page 17)

15
NOTE
If the connection between the paired device and the telephone base does not
resume by manually connecting the device on the paired device list, you will
need to unpair or de-register the device from the Bluetooth enabled mobile
phone. Make sure the device is no longer on the paired list after deregistration;
then follow the steps in section “Pairing a Bluetooth enabled mobile phone” or
“Pairing a Bluetooth headset” as above to start the pairing procedures again.
Replace a paired device
If you want to pair and connect a new device when there are
already two devices paired with the telephone base, press
and hold the Bluetooth button (which you want to terminate
the corresponding connection) on the telephone base until the
corresponding Bluetooth LED is flashing, the connection via this
Bluetooth button will be terminated automatically, then start with
step two of section “Pairing a Bluetooth enabled mobile phone”
or “Pairing a Bluetooth headset”. If you do not pair a new device
within two minutes, the Bluetooth LED flashes on the telephone
base will turn off and the system will return to idle mode.
introduCinG Bluetooth