Radio Shack 43-5862 - Manual (Page 59)

Beyond the Basics
4. To cancel paging, press any key on the found handset or
press END/PAGE on the base.
NOTE
If the battery pack is completely drained, the
handset will not beep when paging.
Using Hold, Conference and Transfer
Placing a Call on Hold
1. During a call, to place the caller on hold:
HANDSET: Press INTCM/HOLD.
BASE:
Press BACK/HOLD/INTERCOM.
If you leave a caller on hold for more than ten seconds, the
display screen will read, HOLD.
2. To return to the party on hold:
HANDSET: Press /FLASH or SPEAKER.
BASE:
Press /FLASH.
The phone will return to the holding party.
NOTES
You can only place a caller on hold for 5 minutes.
Once 5 minutes has passed, that party’s line will
be disconnected and the phone will return to
standby.
While a call is on hold, Caller ID and Call Waiting
cannot be received. •
•
Conferencing
If you have more than one handset, up to four people can
participate in a conference call. A four-way conference call
consists of an outside line, two handsets, and the base
speakerphone. You can easily join a call already in progress.
1. To join the call:
HANDSET: Press /FLASH or SPEAKER.
BASE:
Press /FLASH.
UP01799ZZ_1.indb 59 4/12/2006 12:43:49 PM