Radio Shack 43-5862 - Manual (Page 16)

The Basics
1
Insert the supplied AC
adapter’s barrel plug into
the DC IN 9V jack on the
bottom of the base.
Route the adapter’s cord
through the strain relief slot
on the base of the phone.
Then plug the adapter into a
standard AC outlet.
CAUTION: You must use a Class 2 power source
that supplies 9V DC and delivers at least 400 mA
(for the base)/210 mA (for the charger). Its center
tip must be set to positive and its plug must fit the
phone’s DC IN 9V jack. The supplied adapter meets
these specifications. Using an adapter that does
not meet these specifications could damage the
phone or the adapter.
On a Wall Plate or Wall
To mount the phone directly on a wall, you need two screws (not
supplied) with heads that fit into the keyhole slots on the base.
Drill two holes 3 15/16 inches apart. Thread a screw into each
hole, letting the heads extend about 1/8 inch.
Plug the supplied AC adapter’s barrel plug into the DC IN 9V
jack on the bottom of the base.
Route the adapter cord through the base’s groove.
Plug one end of the supplied modular cord (short for a wall
plate, long for direct wall mounting) into the TEL LINE jack
on the bottom of the base.
3.
4.
1.
2.
3.
UP01799ZZ_1.indb 16 4/12/2006 12:43:29 PM