Radio Shack 43-5862 - Manual (Page 21)

1
The Basics
Installing a Belt Clip
To Attach the Belt Clip
Insert the belt clip into the holes on each
side of the handset. Press down until it
clicks.
To Remove the Belt Clip
Pull either side of the belt clip to release
the tabs from the holes.
Using a Headset
You can make or answer calls handsfree using an optional
headset that has a 3/32-inch (2.5-mm) plug. Your local
RadioShack store has a variety of headsets available.
To connect the headset, gently flip open
the rubber headset jack cover on the
side of the handset. Then insert the
headset’s plug into the jack.
Use
or on the handset to adjust
the headset’s volume.
With a headset connected, you can
make or answer calls as usual using the
keys on the handset.
When you finish using the headset, disconnect it from the
handset and close the rubber cover to protect the jack.
NOTES
Always place the handset properly on the base
whenever you are recharging the handset.
You can use a handset holder (available from
your local
RadioShack store) to hang the handset
on your belt for added convenience when using a
headset.
•
•
1.
2.
3.
4.
UP01799ZZ_1.indb 21 4/12/2006 12:43:32 PM