RCA ProV950HB - Manual (Page 72)

68
P R O V 9 5 0 H / p p . 0 6 8 - 0 7 5 ; 9 6 / 4 / 3 0 / 1 6 : 0 0
G. K . A s s o c i a t e s , To k y o
Signal System: NTSC standard
Recording System: 2 rotary heads, helical scanning system
Cassette: 8 mm video tape, MP type or Hi8 MP, ME type
Recording/Playback Time: 120 minutes (P6-120)
Tape Speed: 14.345 mm/second
Pickup Device: 1 ⁄ 4
Љ (6.4 mm, effective size: 4.5 mm) CCD image sensor (with
approx. 410,000 pixels including optical black)
Lens: 12 ן power zoom lens (F1.8, fס4.2–50.4 mm), full-range auto
focus
Lens Filter Diameter: 37 mm
Monitor: 4 Љ (10.1 cm)—full-color LCD screen (TFT active matrix)
Microphone: Electret stereo microphone
Power Requirement: DC 3.6 V
Power Consumption: 7.1 W (during camera recording in full auto mode with zoom
motor off, backlight in normal mode)
Operating Temperature: 0 ЊC to ם40ЊC (32ЊF to 104ЊF)
Operating Humidity: 30% to 80%
Storage Temperature: מ20ЊC to ם60ЊC (מ4ЊF to 140ЊF)
Dimensions (approx.): 7 15 ⁄
32
Љ (W) ן 4 19 ⁄
32
Љ (H) ן 3 13 ⁄
16
Љ (D) [190 mm (W) ן 117 mm (H)ן
97 mm (D)]
Weight (approx.): 1.8 lbs (820 g) (without battery pack, lithium battery, video
cassette)
Specifications
AC Adapter/Battery Charger
Power Requirement: AC 100–240 V, 50/60 Hz
DC Output: 4.5 V
Power Consumption: 25 W
Dimensions (approx.): 4 3 ⁄ 4
Љ (W) ן 2Љ (H) ן 4Љ␣ (D) [120 mm (W) ן 51 mm (H) ן 101.5␣ mm (D)]
Weight (approx.): 0.86 lbs (390 g)
Specifications are subject to change without notice.
This equipment has been tested and found to comply with the limits for a Class B
digital device and RF lighting device pursuant to Part 15 and Part 18 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
— receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
INFORMATION TO USER
This device complies with Part 15 and Part 18 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.