Renesas Emulator System M3T-MR100 - Manual (Page 275)

259
Warning messages
The following message are a warning. A warning can be ignored providing that its content is understood.
cfg100 Warning : system is not defined (xxxx.cfg)
cfg100 Warning : system.XXXX is not defined (xxxx.cfg)
System definition or system definition item XXXX is omitted in the configuration file.
cfg100 Warning : task[x].XXXX is not defined near line xxx (xxxx.cfg)
The task definition item XXXX in ID number is omitted.
cfg100 Warning : Already definition XXXX near line xxx (xxxx.cfg)
XXXX has already been defined.The defined content is ignored, check to delete the extra definition.
cfg100 Warning : interrupt_vector[x]'s default is not defined (default.cfg)
The interrupt vector definition of vector number x in the default configuration file is missing.
cfg100 Warning : interrupt_vector[x]'s default is not defined near line xxx (xxxx.cfg)
The interrupt vector of vector number x in the configuration file is not defined in the default configuration file.
cfg100 Warning : Initial start task is not defined
The task of task ID number 1 was defined as the initial startup task because no initial startup task is defined in
the configuration file.
cfg100 Warning : system.stack_size is an uneven number near line xxx
cfg100 Warning : task[x].stack_size is an uneven number near line xxx
Please set even size in system.stack_size or task[x].stack_size.
cfg100 Warning : system_IPL should be 7
When "-Wipl" is specified as the command option of KONFIGYURETA, you should make the value of sys-
rem_IPL of a system definition 7.
cfg100 Warning : Timer counter value is less than your settimg time
The error occurred in the operation of a timer count. Please check whether an error is permitted.
cfg100 Warning : XXXX is specified as YYYY.
XXXX is specified as YYYY.