Radio Shack PRO-93 - Manual (Page 63)

63 Trunking Operation
Clearing All Talk Group IDs in One Bank
You can clear all talk group IDs within a bank. This lets
you quickly delete all talk group IDs from a bank if you
want to use the bank to store different data (such as a
new set of talk group IDs).
1. Press PGM .
2. Press TRUNK to enter a talk group ID memory
mode.
3. Select a talk group ID bank using FUNC ,
8 8 8 8
or
9 9 9 9
.
4. Press FUNC then 6 . áFE=@IDý C@JKý :C<8I áFE=@IDý C@JKý :C<8I áFE=@IDý C@JKý :C<8I áFE=@IDý C@JKý :C<8Iе е е е
ээээ
сж5!/ сж5!/ сж5!/ сж5!/
,I ,I ,I ,I appears.
5. Press 1 to clear the all talk group IDs within a bank.
(@JKý (@JKý (@JKý (@JKý:C :C :C :C<8I<; <8I<; <8I<; <8I<; appears.
Note: To cancel the deletion, press any key except 1 .
The scanner returns to the talk group ID memory mode.
OPEN AND CLOSED MODES
When set to the open mode, the scanner stops on any
ID code and only uses the ID list to look up ID text tags.
When set to the closed mode, the scanner stops only on
signals that have an ID code which is found in the ID list
for the bank.
Note: When you select a channel manually, any trans-
mission opens squelch, regardless of the current mode.
The open or closed mode is set in each channel storage
bank.
ц ц ц ц
ээээ
(open)
ээээ
or V V V V (closed) appears under the channel
storage bank's number while scanning. Or, the status
display shows the
ц ц ц ц or V V V V at the top line while the scanner
is in manual mode or receiving a signal during scanning.
When no ID code is programmed into the scanner, it re-
ceives the signal in MOT or ED mode. In open mode the
scanner stops on any transmission. If the ID is stored,
the text tag appears in the display. Otherwise, the talk
group ID appears in the display. In closed mode the
scanner only stops on a transmission if the ID is stored.