Radio Shack PRO-93 - Manual (Page 12)

12
Preparation
When battery power is low, (FNэ в8KK (FNэ в8KK (FNэ в8KK (FNэ в8KK appears and
the scanner beeps continuously. When battery power is
depleted, the scanner turns itself off. Replace all four
non-rechargeable batteries, or recharge the recharge-
able batteries. See “Charging Rechargeable Batteries”
on Page 12.
Warning: Always dispose of old batteries promptly and
properly. Do not bury or burn them.
Caution: If you do not plan to use the scanner with bat-
teries for a month or longer, remove the batteries. Bat-
teries can leak chemicals that can destroy electronic
parts.
Charging Rechargeable Batteries
Your scanner has a built-in charging circuit that lets you
charge nickel-metal hydride (Ni-MH) or nickel cadmium
(Ni-CD) rechargeable batteries (not supplied) while they
are in the scanner. To charge rechargeable batteries,
connect an appropriate AC or DC adapter to the
PWR DC
9V jack. For best results we recommend RadioShack re-
chargeable nickel-metal hydride (Ni–MH) 1500mAh bat-
teries.
Notes:
• To charge batteries with a DC adapter from a DC
power source, you must use a 9V, 300 mA DC
adapter such as RadioShack Cat. No. 273-1810 or
273-1815 and a size C Adaptaplug™ (neither sup-
plied). Both are available at your local RadioShack
store. Make sure the adapter's voltage is set to 9V.
• It takes about 15 hours to recharge fully discharged
1500mAh Ni–MH rechargeable batteries. You can
operate the scanner while recharging the recharge-
able batteries, but charging takes longer.
• The scanner can also charge Ni-Cd batteries.
600mAh batteries require 6 hours and 850mAh bat-
teries require 8 hours to charge.
• When you charge Ni-Cd batteries, pay attention not
to over charge. Overcharging shortens battery life.