Programming motorola trunking systems (uhf-lo) – Radio Shack PRO-93 User Manual

Page 54

Trunking Operation

to access the next open channel then enter the

frequencies. (See “Storing Known Frequencies into
Channels” on Page 25).

7. Press

SCAN

to start scanning.

Notes:

• If you make an error in the entry process, press

as often as needed to erase the incorrect data.

• If you enter a frequency that has already been

entered, the scanner sounds an error tone and dis-
plays

LGCôý=

and the channel number that has been

duplicated. If the dual entry is an error press

and

enter the correct frequency. If the dual entry is inten-
tional press

ENTER

to accept.

• You may replace any frequency by selecting the

bank and channel, pressing

PGM

and entering the

new frequency.

Programming Motorola Trunking Systems
(UHF-Lo)

You can program the scanner to receive transmissions
in the UHF-Lo band (406-512 MHz) of the Motorola
trunking system. You can receive these transmissions
by checking the trunking system's control channel. You
must program the system's base frequency and offset
frequency to do this.

Notes:

• Base and offset frequencies vary for each type of

trunking system. You can get information about
these frequencies for the trunking system you want
to scan using www.trunkscanner.com, other Internet
sources, or locally-published guidebooks.

,òòñUôô

,òòñUôô фц")

фц")

тфттттт

в8EBýòý

â8EBýòý

â8EBýòý б?этс

б?этс

Next channel