Radio Shack PRO-93 - Manual (Page 36)

36
Operation
4. Press ENTER to set the frequency. The cursor
moves to $ $ $ $ . If the entered frequency is incorrect,
%EM8C@;ý"I %EM8C@;ý"I %EM8C@;ý"I %EM8C@;ý"I briefly appears.
5. Enter your desired higher-end frequency and press
ENTER .
6. Rotate SQUELCH clockwise and leave it set to a
point just after the hissing sound stops.
7. Press SEARCH to start searching. When the scan-
ner finds an active frequency, it stops searching.
Special Notes:
• You can copy and save a frequency into a specified
bank, channel, or priority channel when the scanner
finds an active frequency. See “Using Frequency
Copy Function” on Page 39 to save the frequency.
The frequency copy functions only in search banks
2, 3, 4 and 5.
• While the scanner is searching, you can use the
seek search by pressing FUNC then 7 . The display
indicates /< /< /< /< at the bottom line. The scanner
stops at an active frequency for five seconds and
restarts searching automatically. The scanner
repeats this operation.
• You can set Zeromatic on or off by pressing FUNC
then 0 . Press FUNC then 0 again to reverse the Zer-
omatic setting. Whenever this feature is turned on,
6 6 6 6 D D D8K@: 8K@: 8K@: 8K@:ээээ+* +* +* +* briefly appears then Q Q Q Q appears at the
first digit of the second line and the scanner stops at
the correct frequency. When you turn this feature
off,
Q Q Q Q disappears and the scanner stops when it
detects an active signal. Zeromatic functions only in
search bank 2, 3, 4 and 5.
• There are several group banks in SR2 Police/Fire
and SR4 ham bands. You can turn off or on the
groups by pressing the group numbers. For exam-
ple to turn off
т т т т , press 0 .
• In the Air and the Limit search bands, press FUNC
then
8 8 8 8
to start searching up from the lowest fre-