Radio Shack PRO-93 - Manual (Page 55)

55 Trunking Operation
• If you try to program an offset frequency in the UHF-
Hi bands (806-960 MHz), the scanner ignores the
entry.
Follow these steps to program Motorola trunking fre-
quencies in the UHF-Lo band:
1. Press PGM then TRUNK to enter the ID program
mode.
2. Press FUNC and press (or hold)
8 8 8 8
or
9 9 9 9
to select
the bank.
3. Press MODE and select )+0 )+0 )+0 )+0 .
4. Press FUNC then 2 . The display indicates â8J< â8J< â8J< â8J<
=I =I =I =I on the first line, о о о отмф тмф тмф тмфтттт тттт тттт тттт on the second line,
E\\i[j E\\i[j E\\i[j E\\i[j0000ý).& ý).& ý).& ý).&
on the third line and /K /K /K /K ýðíôòB$Q ýðíôòB$Q ýðíôòB$Q on the
bottom line.
5. While в в в в in â8J< â8J< â8J< â8J< blinks, if necessary, press the
desired Base frequency with the number keys and
press
ENTER . Confirm the entry. If it is incorrect,
press the number keys again to set the base fre-
quency. After you confirm the input, press
ENTER
again.
6. While
Eý Eý Eý Eý
in
E\\i[j E\\i[j E\\i[j E\\i[j
blinks, if necessary, enter the offset
number and press ENTER . Confirm the entry. If it is
incorrect, then press the number keys again to set
the frequency. After you confirm the input, press
ENTER again.
7. While / / / / in /K /K /K /K blinks, repeatedly press
8 8 8 8
or
9 9 9 9
to
select the step number, рнфт рнфт рнфт рнфт , нтфт нтфт нтфт нтфт or ñðôíýB$Qõ ñðôíýB$Qõ ñðôíýB$Qõ ñðôíýB$Qõ then
press ENTER .
8. Press PGM to enter the program mode. Store the
trunking IDs into the sub-bank in the same bank.
Programming Motorola Trunking System
(800 MHz)
Notes:
• On the 800 MHz trunking band, you can select a
base frequency (normal or offset).