beautypg.com

Troubleshooting, Power source, Recording and playback – Ricoh Camera RDC-i700 User Manual

Page 132

background image

130

Troubleshooting

Refer to the pointers listed below before submitting the equipment for repairs. If
the problem persists after trying the suggestions, contact your nearest Ricoh
service office.

Power Source

Problem

Power will not
come on

Power cuts out

Battery will not
charge

Battery quickly
consumed

Cause

Battery not loaded or battery
exhausted

AC adapter not properly connected

No operation performed so auto
power off function was activated

Battery exhausted

Battery at end of service life

Camera operated in extremely high
or low temperature environment

Camera operated in dark
environment requiring frequent use
of flash

Remedy

Insert battery correctly or charge battery.

Connect correctly.

Switch camera on again.

Charge battery.

Replace with new battery.

Page

P.15
P.16

P.18

P.24

P.15

P.16

Recording and Playback

Problem

Cannot confirm
shot image

No image on
LCD monitor

Cause

Battery not loaded or battery
exhausted

No power, or mode dial not set

Shutter release button not fully
pressed (pressed halfway)

CF card or PC card not formatted

No memory space on CF card or PC
card

No space in internal memory

CF card or PC card at end of
service life

Self-timer on

Flash charging

CF card or PC card contact surface
dirty

LCD confirmation time too short

No power or LCD monitor is dark

Video system is set on PAL and
video cable is still plugged in.

Remedy

Insert battery correctly or charge battery.

Switch on and set mode dial to recording
mode.

Press shutter release button all the way.

Format card.

Delete unnecessary files or insert new card.

Delete unnecessary files.

Insert new card.

Press

to disengage self-timer mode.

Wait until flash LED stops blinking.

Clean with soft dry cloth.

Increase LCD confirmation time.

Switch on and press DISPLAY button to
display image on LCD monitor, or adjust
monitor contrast using LCD contrast
adjustment buttons.

Set video system to NTSC or disconnect
video cable.

Page

P.15
P.16

P.25

P.55

P.43

P.20

P.112

P.112

P.20

P.67

P.56

P.120

P.28
P.49
P.87

P.88

P.119

Shutter release
button pressed
but no image
recorded