Adjusting the height (y), Pre l iminar y – Runco QUANTUM COLOR Q-750I User Manual
Page 55
Q-750i Series Installation/Operation Manual
39
PRE
L
IMINAR
Y
3.
Slowly move the anamorphic lens into place (from right to left or vice versa) so that
there are no shadows on either side of the screen:
4.
When the horizontal position is properly set, tighten the Yaw/X-Adjustment Levers to
secure the lens in place.
Adjusting the Height (Y): With the white field still on-screen, loosen the
Height/Y Adjustment T-Screws on either side of the lens. Then, slowly move the
anamorphic lens into place so that there are no shadows on the top or bottom of the
screen:
When the height is properly set, tighten the Height Adjustment T-Screws to secure the
lens in place.
Too Far Right
Too Far Left
Correct position
Too High
Too Low
Correct position