Runco QUANTUM COLOR Q-750I - Manual (Page 28)

Installation
12 Q-750i Series Installation/Operation Manual
PRE
L
IMINAR
Y
3.2
Quick Setup Table 3-1 gives a quick overview of the RS-900/RS1100 installation process. The sections
following this one provide detailed instructions.
Installation should be performed by a qualified custom video
installation specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1 Choose a location for the projector 13
2
If installing a CineWide-equipped projector: Install
AutoScope lens motor or fixed CineWide base plate
(optional) 19
3 Mount the projector 26
4 Connect signal sources to the Q-750i 27
5 Connect external controller to RS-232 port (optional) 31
6
Connect 12-volt trigger output to AutoScope lens motor or
other equipment (optional) 32
7 Apply power to the projector 33
8
Primary lens adjustments: focus, projected image size
(zoom) and position (shift) 16, 34
9 Change the OSD Language (optional) 35
10
For rear-screen and/or ceiling-mount installations, select
the proper picture orientation 35
11 Install CineWide anamorphic lens (optional) 36
12
CineWide lens adjustments: position, pitch (angle),
geometry and focus 38
13
Projector calibration: adjust the following for each input;
save settings when finished:
Aspect ratio
Brightness
Contrast
Color level
Tint
Input position
46
Note