Roland E-80 - Manual (Page 21)

Front panel
E-80 Music Workstation r
21
Switching the E-80 on/off
After connecting the E-80 to the other devices, proceed as follows:
Internal Memory Protect
After unpacking your E-80 –and before switching it on– you
need to defeat the protection of its internal memory (a solid-
state hard disk) if you intend to save data in the internal
memory.
• Slide the switch to the “ ” position to unlock the memory.
(To once again lock the internal memory, slide the switch
back to the “
” position.)
Switching on the E-80
(1) Insert the included power cable into the AC inlet and
then plug it into an electrical outlet.
(2) Press the E-80’s [POWER¥ON] button located at the far
left.
(3) If you connected the E-80 to a mixing console, switch it on now.
(4) Switch on the amplifier, your active speakers or the keyboard amplifier(s).
(5) Use the MASTER [VOLUME] knob to set the E-80’s out-
put volume.
Setting the display contrast
The information in the LCD display may be difficult to view
after turning on your E-80 or after extended use. Your
viewing angle or the current lighting conditions can also
affect the appearance of the display.
In such cases, use the [LCD¥CONTRAST] knob to the left of
the display to adjust the contrast.
Switching off the E-80
(1) Switch off all external devices.
(2) Use the E-80’s [POWER≈ON] button to switch it off.
Note: If you need to turn off the power completely, first turn off the POWER switch, then unplug the power cord from the power outlet.
Note: Be sure to wait 2~3 seconds before switching the E-80 back on.
VOLUME