Roland BOSS DIGITAL RECORDER MICRO BR - Manual (Page 68)

68
Section 3. Using effects
By adding sounds which are out-of-phase with
the direct sound, this effect enhances the
definition of the sound, and pushes it to the
forefront.
On/Off OFF, ON
This parameter turns the enhancer effect on/off.
Sens 0 – 100
Adjusts the manner in which the enhancer will be
applied relative to the input signals.
Frequency 1.0 – 10.0 (kHz)
Adjusts the frequency at which the enhancer
effect will begin to be applied. The effect will be
made apparent in the frequencies above the
frequency set here.
Mix Level 0 – 100
Adjusts the amount of phase-shifted sound of the
range set by “Frequency” that is to be mixed with
the input.
Low Mix Level 0 – 100
Adjusts the amount of phase-shifted sound of the
lower range that is to be mixed with the input.
The frequency range in which the effect is
applied is fixed.
Level 0 – 100
Adjusts the volume of the enhanced sound.
A 4-band equalizer.
On/Off OFF, ON
This parameter turns the equalizer effect on/off.
Low Gain -20 – +20 (dB)
This parameter sets the gain (amount of boost or
cut) for the bass equalizer.
Low-Mid Gain -20 – +20 (dB)
This parameter sets the gain (amount of boost or
cut) for the low-midrange equalizer.
Low-Mid Freq 100 – 10.0k (Hz)
This parameter sets the central frequency for the
low-midrange equalizer.
Lo-Mid Q 0.5 – 16
This parameter sets the range of change in gain
for the frequency set by “Lo-M F.” A larger value
results in a narrower range of change.
High-Mid Gain -20 – +20 (dB)
This parameter sets the gain (amount of boost or
cut) for the high-midrange equalizer.
High-Mid Freq 100 – 10.0k (Hz)
This parameter sets the central frequency for the
high-midrange equalizer.
High-Mid Q 0.5 – 16
This parameter sets the range of change in gain
for the frequency set by “Hi-M F.” A larger value
results in a narrower range of change.
Hi Gain -20 – +20 (dB)
This parameter sets the gain (amount of boost or
cut) for the treble equalizer.
Level -20 – +20 (dB)
This parameter adjusts the volume after the
equalizer stage.
This produces a flanging effect that gives a sort of
“twisting” character to the sound.
* This effect can be used when the FX “Type” parameter
is set to “FLANGER.”
On/Off OFF, ON
This parameter turns the flanger effect on/off.
Rate 0 – 100
Determines the rate of the flanging effect.
Depth 0 – 100
Determines the depth of the flanging effect.
Manual 0 – 100
Adjusts the center frequency at which to apply
the effect.
Resonance 0 – 100
Determines the amount of resonance (feedback).
Increasing the value will emphasize the effect,
creating a more unusual sound.
Enhancer
4-band Equalizer
Flanger
MICRO-BR_e1.book 68 ページ ２００６年８月１日 火曜日 午後１２時６分