Roland XP-30 - Manual (Page 148)

148
Parameter List
CONTROL Group (p. 73)
Display Parameter Value
KEY MODE&BENDER Assign Key assign mode POLY, SOLO
Legato Solo legato switch OFF, ON
Bend Range Bend range down -48–0 semitone
Bend range up 0–+12 semitone
PORTAMENTO Sw Portamento switch OFF, ON
Time Portamento time 0–127
Mode Portamento mode NORMAL, LEGATO
Type Portamento type RATE, TIME
Start Portamento start pitch PITCH, NOTE
RxSWITCH Volume Receive volume switch OFF, ON T
Pan Receive pan control switch OFF, CONT, KEY-ON T
Pitch Bend Receive pitch bend switch OFF, ON T
DAMPER Hold-1 RxSwitch Receive hold-1 switch OFF, ON T
Redamper Redamper switch OFF, ON T
PEAK & HOLD EfxCtrl EFX control peak/hold OFF, HOLD, PEAK
Ctrl 1 Control1 peak/hold OFF, HOLD, PEAK
Ctrl 2 Control2 peak/hold OFF, HOLD, PEAK
Ctrl 3 Control3 peak/hold OFF, HOLD, PEAK
CONTROL SOURCE Control 2 Control source 2 (*1)
Control 3 Control source 3 (*1)
CONTROL 1 Destination Control destination 1–4 (*2) T
Depth Control depth 1–4 -63–+63 T
CONTROL 2 Destination Control destination 1–4 (*2) T
Depth Control depth 1–4 -63–+63 T
CONTROL 3 Destination Control destination 1–4 (*2) T
Depth Control depth 1–4 -63–+63 T
*1: OFF, SYS-CTRL1, SYS-CTRL2, MODULATION, BREATH, FOOT, VOLUME, PAN, EXPRESSION, PITCH BEND, AFTERTOUCH, LFO1, LFO2, VELOCITY,
KEYFOLLOW, PLAYMATE
*2: OFF, PCH, CUT, RES, LEV, PAN, MIX, CHO, REV, PL1, PL2, FL1, FL2, AL1, AL2, pL1, pL2, L1R, L2R
WAVE Group (p. 76)
Display Parameter Value
WAVE Group Wave group INT-A, INT-B, XP-A, XP-B, XP-C, XP-D, XP-E T
Number Wave number 001–255 T
Gain Wave gain -6, 0, +6, +12 dB T
Switch Tone switch OFF, ON T
FXM Switch Frequency cross modulation switch OFF, ON T
Color Frequency cross modulation color 1–4 T
Depth Frequency cross modulation depth 1–16 T
TONE DELAY Mode Tone delay mode (*1) T
Time Tone delay time 0–127/0–880/0–5000 (*2) T
*1: NORMAL, HOLD, PLAYMATE, CLOCK-SYNC, KEY-OFF-N, KEY-OFF-D, TEMPO-SYNC
*2: When the Tone Delay Mode parameter is set to “CLOCK-SYNC” this is set as a Note value.
LFO Group (p. 78)
Display Parameter Value
LFO1 Form LFO form TRI, SIN, SAW, SQR, TRP, S&H, RND, CHS T
Key Sync LFO key Sync OFF, ON T
Rate LFO rate 0–127, 0–880 (*1) T
ExtSync LFO external sync OFF, CLOCK T
Mode LFO fade mode ON-IN, ON-OUT, OFF-IN, OFF-OUT T
Delay LFO delay time 0–127 T
Fade LFO fade time 0–127 T
Offset LFO offset -100, -50, 0, +50, +100 T
LFO2 (*2) T
LFO DEPTH1:2 Pitch Pitch LFO depth 1, 2 -63–+63 T
TVF TVF LFO depth 1, 2 -63–+63 T
TVA TVA LFO depth 1, 2 -63–+63 T
Pan Pan LFO depth 1, 2 -63–+63 T
*1: When the LFO External Sync parameter is set to “CLOCK” this is set as a Note value.
*2: Same as LFO1.