Module status leds, Line modules (lm), Ethernet - copper – RuggedCom RX1512 User Manual
Page 13: 1 module status leds, 3 line modules (lm), 1 ethernet - copper, Modules, see, Section 2.3, “line modules (lm)
RUGGEDCOM RX1512
Installation Guide
Chapter 2
RUGGEDCOM Modules
Module Status LEDs
7
• Serial Console:
Section 3.4, “Serial Console Port”
• Management Ethernet Interface:
Section 3.7, “Copper Ethernet Ports”
• Critical Alarm (Failsafe) Relay Interface:
Section 3.3, “Critical Alarm Wiring”
Section 2.2.1
Module Status LEDs
The front panel module status LEDs provide the following information:
Table: Module Status LED Indications
LED
Purpose
Description
PM
Indicates power supply status.
I = Power supply is receiving input voltage.
O = Power supply is providing
output voltage to the RX1512.
LM 1 through 2
Indicates the line module status.
Green = OK
Orange = Warning alert
Red = Configuration error
Section 2.3
Line Modules (LM)
The RUGGEDCOM RX1512 supports two line modules in slots LM1 through LM2. Several types of line modules
may be ordered, depending on the type, speed and number of Ethernet ports required.
The following illustrations show the typical port configurations and connectors available for RX1512 line modules.
For complete information on the available line modules, refer to the RUGGEDCOM RX1512 data sheet.
NOTE
Only one T1/E1 module may be used per router.
Section 2.3.1
Ethernet - Copper
Figure 3: CG01: 2 × 10/100/1000TX RJ45
Figure 4: CG03: 2 x 8-Pin 10/100/1000TX M12