Ricoh MIB-II - Manual (Page 73)

Operating Instructions Administrator Reference
73
A Press the {{{{U U U U}}}} or {{{{T T T T}}}} key to display "Active Protocol", and then press the {{{{Enter #}}}} key.
B Press the {{{{U U U U}}}} or {{{{T T T T}}}} key to display "NetWare".
C Press the {{{{Enter #}}}} key.
The current setting appears on the panel display.
GGGG
Select the frame type for NetWare.
Select one of the following items if necessary.
• Auto (Default)
• Ethernet 802.3
• Ethernet 802.2
• Ethernet ll
• Ethernet SNAP
Note
❒ In most situations, use the default setting ("Auto "). When you first select "Auto ", the frame type
first detected by the printer is adopted. If the network can use more than two frame types, the
printer may fail to select the correct frame type if "Auto " is selected. In this case, select the ap-
propriate frame type.
Active Protocol:
TCP/IP
NetWare:
*Active