Ricoh MIB-II - Manual (Page 183)

Operating Instructions Administrator Reference
183
Remote Maintenance by telnet
You can view the printer status and configure the Network Interface Board using telnet.
Note
❒ You should specify a password so that only the network administrator, or a person having network
administrator privileges, can use remote maintenance.
Using telnet
The following is a sample procedure in using telnet.
Limitation
❒ Only one person at a time can be logged on to do remote maintenance.
AAAA
Use the IP address or the host name of the printer to start telnet.
% telnet IP_address
Note
❒ In order to use the host name instead of the IP address, you must write it to the "/etc/hosts" file.
BBBB
Type the password.
Note
❒ The factory default is "password".
CCCC
Type a command.
Reference
For more information about telnet commands, see p.184 “Commands List” .