Roland HPi-5 - Manual (Page 48)

48
Connecting External Devices
Local Control setting
If the data that is produced when you play the keyboard is sent to
the sound generation section via both routes (1) and (2) as shown in
the diagram, notes will be doubled or may be interrupted. To
prevent this, use the “Local Off” setting to disconnect route (1).
Set Local Off if you have connected the HPi-5 to a MIDI sequencer.
fig.local.e
* When a Roland MT series instrument is connected, it is not
necessary to make the Local Off setting. The MT transmits a
Local Off message when the power is turned on. If you turn on
the power in the order of the HPi-5 → MT series, Local Off will be
set automatically.
Composer Out setting
If you want a performance recorded on the HPi-5 to be transmitted
to an external MIDI device or computer, turn the “Composer Out”
setting “On.”
Program Change setting
Program changes are a type of message that tell a device to “switch
to sound number ‘x’.” A device that receives this message will select
the sound of the corresponding number.
When you use this setting to specify a program change (program
number), that program number will be transmitted to a MIDI device
connected to the HPi-5. A MIDI device that receives the program
number will switch to the sound corresponding to that program
number.
Normally, program changes select from 128 different sounds.
However, some MIDI devices have more than 128 sounds. For such
devices, Bank Select messages are combined with Program Change
messages to select sounds. Bank Select consists of two messages:
MSB (controller number 0; value: 0–127), and LSB (controller number
32; value: 0–127).
* Some MIDI devices cannot use bank select messages.
Alternatively, some devices may use bank select messages, but
ignore the LSB message.
Item Explanation Setting
Local Control
Switch the Local Con-
trol setting on/off.
On, Off
Item Explanation Setting
Composer Out
Specify whether a re-
corded performance
will be transmitted to
a MIDI device.
On, Off
(1)
MIDI
MIDI MIDI
MIDI
(2)
IN
IN OUT
OUT
Sequencer
Memory
Sound
Generator
Each note played
is sounded twice
Thru function On
Local On
Item Explanation Setting
Bank Select
MSB
Transmit the
bank select MSB.
0 (00h)–127 (7FH)
Bank Select
LSB
Transmit the
bank select LSB.
0 (00h)–127 (7FH)
Program
Change
Transmit the pro-
gram number.
1 (00h)–128 (7FH)
HPi-5_e.book 48 ページ ２００４年１２月２１日 火曜日 午後１２時４６分