Roland AT 5 - Manual (Page 46)

46
Record and Playback Your Performance
Rerecording Performance Data
Recorded on the AT-5
You can record over recorded performance data.
fig.08-08
1.
Press the [Rec] button to enter into the recording standby
mode.
The [Rec] button indicator will light, and the [Play/Stop] button indicator
will blink.
The point at which recording begins is returned to the beginning of the song.
2.
Press the [Play/Stop] button to start recording.
When you press the [Play/Stop] button, the metronome will play two
measures (bars) of count-in before recording begins.
During recording, the performance data is played back, and the data for the
performances on the upper part and lower part is recorded over again.
3.
Press the [Play/Stop] button when your recording is
completed.
The [Rec] button and the [Play/Stop] button indicators will go dark.
NOTE
If you wish to re-record
with different settings for
voices, tempo, part balance,
erase the recorded song (p.
47) and re-record again. If
the Control track still
contains data from before
you re-recorded, the
volume or sounds may
change during playback.
2, 3 1
You can re-record the bass
performance. For details
refer to “Re-recording the
Bass Performance” (p. 60).
NOTE
If you wish to keep the
existing Expression Pedal
data, and record only the
panel operations, you can
make settings to prevent
the operation of the
Expression Pedal from
being recorded (p. 60).