Nortel Networks Application Server 53r 5300 00 - Manual (Page 102)

102 Maintenance Releases
If the versions do not match, upgrade the firmware.
--End--
Installing the firmware upgrades
Use these procedures to install firmware upgrades.
Installing the firmware updates navigation
•
"Installing BIOS firmware upgrades" (page 102)
•
"Installing Base Management Controller (BMC) firmware upgrades"
(page 103)
• "Installing diagnostics firmware upgrades" (page 104)
• "Installing RSA-II card firmware upgrades" (page 105)
• "Installing NIC firmware upgrades" (page 106)
• "Installing hard drive firmware upgrades" (page 106)
• "Installing ServeRAID firmware upgrades" (page 107)
Installing BIOS firmware upgrades
Use this procedure to install upgrades to the BIOS firmware. This
procedure requires the reboot of the server.
Prerequisites
• You must be assigned to the SSA role (ntsysadm).
• You must have the CD containing the BIOS firmware upgrade file.
Procedure Steps
Step Action
1 Load the BIOS firmware upgrade CD into the CD-ROM drive.
2 Log on to the server as the SSA role (ntsysadm).
3 Reboot the server.
sudo reboot
4 If the operating system has been installed, change the boot
sequence so that the CD-ROM is the primary boot device by
doing the following:
•
When the BIOS information appears, press F12 to select the
boot sequence.
• Select CD-ROM as the primary boot device.
Otherwise, wait for the server to reboot.
Application Server 5300
Nortel AS 5300 Installation
NN42040-300 01.04
4 November 2008
Copyright © 2007-2008 Nortel Networks
.