Creating a video wall, Cable management, Clamp mounting hole cables – NEC PX-42XM4A User Manual
Page 7: In/o u t ), Mono ), En-6
En-6
Back of the unit
mounting holes
Back of the unit
mounting holes
Note:
1. The VIDEO1 and RGB1 terminals can be used for either INPUT or OUTPUT.
When LOOP OUT is ON, do not connect an OUTPUT signal from another unit as it may damage the other unit due to an
extraordinary load.
2. LOOP OUT can not be turned ON while signals are input to the RGB1 terminal.
3. LOOP OUT can be turned ON while signals are input to the RGB1 terminal if the POWER is switched ON.
Information
• To loop signals out to another plasma display, set the LOOP OUT to ON.
• To create a video wall, set the VIDEO WALL menu items properly.
• To connect monitors, please use a 1~2m (3.3~6.6 feet) BNC cable (any commercially available cable).
• If the image quality is poor, do not use the monitor’s out terminal. Use a distribution amplifier (any commercially
available distribution amplifier) to connect the split signals to the respective monitor INPUT terminals.
• Being used as a video wall function, maximaly 4-screen is rough-standard with lower than 1024
ן768, 60Hz
signal.
• A distribution amplifier is particularly recommended when creating a 3
ן3 (or greater) video wall.
• When looping from plasma to plasma, a 1~2m (3.3~6.6 feet) 15 pin male D-Sub - 5BNC conversion cable is
required.
Creating a video wall
With built-in matrix display capability, you can create a (2
ן2, 3ן3, 4ן4, 5ן5) video wall.
• Connect signal cables and remote cables as shown below.
Video signal
RGB/DVD/HD signal
VIDEO
(IN/O
U
T
)
VIDEO
1
VIDEO
2
VIDEO
3
AUDIO
1
DVD
1
R
(MONO
)
L
Y
IN
OUT
REMOTE
BNC connector
RCA phono plug
OUT
VIDEO Signal
IN
IN
OUT
Remote
control
VIDEO Signal
Remote
control
RGB
2
/
DVD
2
/
HD
2
RGB
1
R/
VD
G/
B
/
HD
(IN
/O
U
T
)
C
r/
P
r
Y
Cb/Pb
IN
OUT
REMOTE
BNC connector
RGB signal/
DVD/HD signal
IN
OUT
IN
OUT
Remote
control
RGB signal/
DVD/HD signal
Remote
control
Cable Management
Using the cable clamps provided with the plasma display; Bundle the signal and audio cables at the back of the unit to
connect to the display.
To attach
To detach
clamp
mounting hole
cables
1.
2.
42 inch
50/61 inch