Nortel Networks Enterprise Edge Feature Programming Telephone - Manual (Page 68)

68 Forwarding your calls
Enterprise Edge Feature Programming Telephone Guide P0908510 Issue 01
• use the internal number of your voice mail as the destination when you program
Forward no Answer and Forward on busy
or
• make the ring delay greater than the delay used by your voice mail system, if
your voice messaging system or service automatically retrieves calls
Displays
Line Redirection
Line Redirection allows you to send your external calls to a telephone outside the
office. You may choose to redirect all your external lines or only some of them.
Line Redirection takes precedence over the Call Forward feature. If both features
are active on a set, incoming external calls on redirected lines are routed to the
specified Selective Line Redirection (SLR) external destination. Incoming internal
calls are forwarded to the specified Call Forward destination.
You cannot use the Line Redirection feature on either a M7100 telephone or a
telephone connected to an Enterprise Edge ATA2 or an Enterprise Edge ASM.
Turning on Line Redirection
ƒ°›
1. Press ƒ°› .
2. Select the outgoing line to be used for redirected calls.
3. Enter the number to which calls are redirected (the ways you can do this are
listed below).
4. Select the lines to be redirected.
Enter the telephone number to which you want to redirect calls, using one of the
following methods:
• Press an external autodial button.
There are several reasons why you may get this
message. For instance, you cannot forward your calls
to a telephone that has been forwarded to your
telephone.
Your calls are being forwarded to telephone 221.
Two or more telephones are linked in a forwarding
chain, and one of them is out of service or is being
used for programming.
For other displays, see Common feature displays on page 149.
Forward denied
Forward>221
CANCL
Not in service